Blade Carriage To Redial Arm Assembly - Craftsman 113.234700 Owner's Manual

Assembly
Blade Carriage to Radial Arm
Assembly
Note: It may be easier to do this assembly
with the parts still in the box because they
are connected by a cord,"otherwise you
may need help to lift both parts out of the
box at the same time.
1. Set out:
-radial arm
-blade carriage.
Stop
Screw
FrontTrim
Radial Arm
Do Not Remove
These Screws
Carriage
Bearings
BladeCarriage
2. Look inside arm towards switch hous-
ing to locate two screws that hold front
trim to switch housing. Remove these
two screws and front trim.
WARNING
Do not remove screws on top of
radial arm. Removal of these
screws affects integrity of switch
assembly and can create an electri-
cal hazard.
3. Use 9/64" h ex wrench to remove front
carriage stop screw and bumper from
end of arm.
4. Use v2"wrench to loosen carriage
stop screw on top of radial ann about
3/4" (enough to let blade carriage clear
when inserted).
Front
Carriage
Stop
Bumper
Radial Arm
Screwa
Front Trim
Switch
16