Craftsman 113.234700 Owner's Manual page 45

Crosscutting
7. Plug saw in.
8. Put yellow key in switch.
9. Grasp and hold onto saw handle, then
tam saw on.
10. Slowly turn elevation handle dock-
wise to lower radial arm until blade
touches table, then continue to lower by
half turn of elevation handle.
11. Hold hand in straight line with saw
handle and pull blade through fence
and across table as far as it will go.
12. Push blade carriage to rearmost posi-
tion, behind fence, and turn saw off.
Continue to hold saw handle until blade
stops spinning.
13. Remove yellow key and unplug saw.
45