Craftsman 113.234700 Owner's Manual page 17

Assembly
5. Position radial arm so that arm is
straight up in air. Lift blade carriage by
saw handle.
CAUTION:
Blade is exposed.
6. Slide blade carriage onto radial arm,
so that carriage bearings fit into radial
arm track. Note: In correct orientation,
single bearing is on left, two bearings are
on right as you look down radial arm.
7. Push rip lock clockwise to lock blade
carriage in place on radial arm.
r
i
Rip
Lock
Lock
8. Re-install front carriage stop screw
and bumper, making sure that nut is still
in bumper and that larger opening of
bumper faces switch housing. Wrench
tighten.
Front
Carriage
Stop Screw
9. Re-install front trim.
10. Wrench tighten carriage stop screw
on top of radial arm.
il
Larger
Opening
17