Output Destination - Kyocera TASKalfa 300i Operation Manual

Output Destination

You can use the procedure below to select an output destination such as the optional document finisher for your
copies.
NOTE:
Optional output destinations include the job separator, built-in finisher, and document finisher.
The table below shows the available output destinations.
Destination
Top tray
Finisher Tray*
Job Separator Tray
* Copy output orientation can be selected either as face-up (print facing up) or face-
down (print facing down).
NOTE:
To change default destination for copies, refer to Paper Output on page 8-13 for details.
Use the procedure below to select the output destination.
Ready to copy.
Paper Output
Place original.
Top Tray
Original : ---
Job Separator
Zoom : 100%
Tray
Paper : ---
Tray 4
Preview
Add Shortcut
Status
Top tray of the machine (where copies are stored)
Tray of the optional built-in finisher or document finisher
Optional job separator
Copies
Face Up
Face Down
Tray A Tray B Tray C
Tray 1 Tray 2 Tray 3
Tray 5 Tray 6 Tray 7
Cancel OK
08/08/2009
Description
1
Press the Copy key.
2
Place the originals on the platen.
3
Press [Org./Paper/Finishing] and then [Paper
Output].
4
Select the output destination for finished copies.
When you select [Finisher Tray], select the
orientation of output copy, Face Up (print facing up)
or Face Down (print facing down).
5
Press [OK].
10:10
6
Press the Start key to start copying.
4-12
Copying Functions