Kyocera TASKalfa 300i Operation Manual page 275

Set the duration of time to execute Auto Drum Refresh. The table below shows the available settings.
Item
Off
Standard
Long
NOTE:
You can also execute Drum refresh as needed (Refer to Drum Refresh on page 8-42.)
Use the procedure below to specify the setting for Auto Drum Refresh.
1
Press the System Menu key.
2
Press [ ], [Adjustment/Maintenance], [
3
Select [Off], [Standard] or [Long].
4
Press [OK].
Correcting Fine Black Lines
Correct fine black lines (black streaks caused by contamination), which may appear on the copies, when the
optional document processor used.
Paper feed
direction
The table below shows the available settings.
Item
Off
On(Low)
On(High)
NOTE:
Using Correcting Fine Black Line can impair reproduction of fine characters. It is recommended to
keep the default ([Off]).
Do not perform Drum Refresh.
Perform Auto Drum Refresh as Standard (maximum 120 seconds).
Perform Auto Drum Refresh as Long (maximum 160 seconds).
] and then [Change] of Auto Drum Refresh.
No correction performed.
Correction performed. The reproduction of the image becomes lower when
using Off.
Correction performed. Select this item if black streak remains after using On
(Low). The reproduction of the image becomes lower when using On (Low).
Description
Description
8-43
Default Setting (System Menu)
8