Send As E-Mail - Kyocera TASKalfa 300i Operation Manual

Send as E-mail

Sends a scanned original image as an E-mail attachment.
NOTE:
• You must have a network environment in which this machine can connect to a mail server. It is
recommended that the machine be used in an environment in which it can connect to the mail server at any
time over a LAN.
• Access the COMMAND CENTER beforehand and specify the settings required for sending e-mail. For
details, see COMMAND CENTER (Settings for E-mail) on page 2-18.
Ready to send.
Place original.
E-mail Address Entry
E-mail
Address
Add a new e-mail destination.
Press [E-mail Address], then enter
the address using the keyboard screen.
Add to Addr Book Next Dest.
Status
Destination
Cancel OK
08/08/2009 10:10
3-22
1
Press the Send key.
Displays the screen for sending.
NOTE:
Depending on the settings, the address book
screen may appear. In this event, press [Cancel] to
display the screen for sending.
2
Press [E-mail Addr Entry] and then [E-mail
Address].
NOTE:
Destination can be specified using the
Address Book or the One Touch Keys. Refer to
Specifying Destination on page 3-28.
3
Enter destination E-mail address and press [OK].
4
Press [Next Dest.] and repeat steps 3 to specify the
destination. Up to 100 E-mail addresses can be
specified.
NOTE:
When [Add to Addr Book] is displayed, the
destinations are registered in the Address Book.
5
Press [OK]. The destinations are registered in the
destination list.
Basic Operation