Kyocera TASKalfa 300i Operation Manual page 326

Symptom
Printouts from the
document processor
have black lines.
Printouts are
wrinkled.
Cannot print.
Documents are
printed improperly.
While the operation
panel was being used,
the keys locked up
and do not respond
when pressed.
Cannot print with USB
memory.
When displaying an
image sent from the
machine on the PC, an
image size is shrunk
vertically or
horizontally.
Checkpoints
Is the slit glass dirty?
Is the paper separator of the
paper feed unit dirty?
Is the paper damp?
Is the paper set in a proper
orientation?
Is the machine plugged in?
Is the machine powered on?
Is the printer cable
connected?
Was the machine powered
on before the printer cable
was connected?
Is Press Status Key...
displayed at the top of the
screen?
Are the application software
settings at the PC set
properly?
Is the operation panel
locked?
Was the USB memory
formatted with a machine
other than this machine?
Is the USB host blocked?
Check that the USB memory
is securely plugged into the
machine.
Have you selected
200×100dpi Normal or
200×400dpi Super Fine for
the scan resolution?
Corrective Actions
Clean the slit glass.
Clean the paper separator.
Replace the paper with new paper.
Change the orientation in which the
paper is positioned.
Plug the power cord into an AC
outlet.
Turn on the main power switch.
Connect the correct printer cable
securely.
Power on the machine after
connecting the printer cable.
Press the Status/Job Cancel key,
[Printing Jobs], and then [Resume
All Print Jobs] to restart printing.
Check that the printer driver and
application software settings are
set properly.
Check the panel lock setting in
COMMAND CENTER and change
the setting if necessary.
Format the USB memory with this
machine.
Select Unblock in the USB host
settings.
—
Select a scan resolution other than
200×100dpi Normal or 200×400dpi
Super Fine when sending an
image.
10-4
Troubleshooting
Reference
Page
9-3
9-4
2-21
—
—
3-2
2-3
2-3
—
—
KYOCERA
COMMAND
CENTER
Operation
Guide
6-20
8-72
—
—