Kyocera TASKalfa 300i Operation Manual page 251

NOTE:
Refer to the Character Entry Method on page Appendix-10 for details on entering characters.
4
Press [OK].
5
Press [Date and Time] to add the date/time to the job, or press [Job No.] to add the job number to the job.
The added information will be displayed in Additional Info.
6
Press [OK].
E-mail Subject/Body
Set the subject and body automatically entered (default subject and body) when sending the scanned originals
by E-mail.
NOTE:
Refer to Send as E-mail on page 3-22.
Use the procedure below to set the default e-mail subject and message body.
1
Press the System Menu key.
2
Press [Common Settings], [
3
Press [Subject] to enter an E-mail subject not more than 60 characters.
NOTE:
Refer to the Character Entry Method on page Appendix-10 for details on entering characters.
4
Press [OK].
5
Press [Body] to enter an E-mail Body not more than 500 characters.
6
Press [OK].
7
Check that the entries are correct and press [OK].
Border Erase Default
Set the default width to be erased as a border. The table below shows the measurement ranges that can be set.
Input units
Inch
Metric
NOTE:
Refer to page 4-17 and page 5-23 for Border Erase.
Use the procedure below to set the default border erase width.
1
Press the System Menu key.
2
Press [Common Settings], [
3
Press [+] or [–] for the Border and Gutter width to erase.
], [Next] of Function Defaults, [
0 to 2" (in 0.01" increments)
0 mm to 50 mm (in 1 mm increments)
], [Next] of Function Defaults, [
8-19
Default Setting (System Menu)
], and then [Change] of E-mail Subject/Body.
Range
] and then [Change] of Border Erase Default.
8