Supply Needed To Complete Job - Lexmark MX710 User Manual

Troubleshooting
Standard network software error [54]
Try one or more of the following:
•
From the printer control panel, touch Continue to continue printing.
•
Turn off the printer, and then turn it back on.
• Update the network firmware in the printer or print server. For more information, contact customer support.
Standard USB port disabled [56]
Try one or more of the following:
•
From the printer control panel, touch Continue to clear the message.
• Enable the USB port. From the printer control panel, navigate to:
Network/Ports > USB Buffer > Auto
Note: The printer discards any data received through the USB port.

Supply needed to complete job

Do either of the following:
•
Install the missing supply to complete the job.
•
Cancel the current job.
Too many disks installed [58]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra printer hard disks.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
Too many flash options installed [58]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra flash memory.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
Too many trays attached [58]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
284