Lexmark MX710 User Manual page 125

Faxing
Tips for this setup:
• To make sure that the phone port on the VoIP adapter is active, plug an analog telephone into the phone port, and
then listen for a dial tone. If you hear a dial tone, then the port is active.
•
If you need two phone ports for your devices, but do not want to pay additional cost, then do not plug the printer
into the second phone port. You can use a phone splitter. Plug the phone splitter into the port labeled Phone Line
1 or Phone Port, and then plug the printer and telephone into the splitter.
Note: Make sure you use a phone splitter, not a line splitter. To make sure that you are using the correct
splitter, plug an analog telephone into the splitter and then listen for a dial tone.
Scenario 4: Digital telephone service through a cable provider
Setup 1: Printer is connected directly to a cable modem
125