Removing The Existing Dimm - Enterasys Diamond Distributed Forwarding Engine 7KR4297-02 Hardware Installation Manual

Memory Locations and Replacement Procedures
Figure B-5
1 Connector arms
3. Rotate the DIMM upwards, then remove it from the connector fingers.
Installing the DIMM
To install a DIMM, refer to Figure
1. Insert the DIMM down between the connector fingers.
2. Pivot the DIMM downward so the tabs on the connector arms align with the two DIMM
alignment notches. With the two connector arms spread outward, push the DIMM down
between the connector arms. Then release the two connector arms to lock the DIMM into
place.
B-6 Mode Switch Bank Settings and Optional Installations

Removing the Existing DIMM

À
2 DIMM
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.
Á
Â
B‐6 and proceed as follows:
À
3 Connector fingers