Enterasys Diamond Distributed Forwarding Engine 7KR4297-02 Hardware Installation Manual page 45

Table 4-1 LANVIEW LEDs (Continued)
LED Color
CPU None
Amber
Green
Red
Green
and
Amber
Amber
and off
RX None
(Receive)
Green
Amber
TX None
(Transmit)
Green
State
Power off.
Blinking. Module in process of
booting.
Solid. Testing.
Blinking. Image starts running.
Solid. Functional.
Solid. Processor in reset.
Blinking. Indicates that the
DFE-Diamond module is in the
process of shutting down.
Alternate (67% on, 33% off).
Indicates that a shutdown
process has completed. This
indication will remain for 60
seconds before automatically
restarting.
No link. No activity. Port
enabled or disabled.
Solid. Link present, port
enabled, no traffic is being
received by the interface.
Flashing. Link present, port
enabled, traffic is being received
by the interface.
Port enabled, but no activity.
Flashing. Indicates data
transmission activity. Rate of
flashing indicates the data rate.
Matrix DFE-Platinum Series Module Installation Guide 4-3
Recommended Action
Ensure chassis has adequate power.
None.
If the LED remains amber for several
minutes, contact Enterasys Networks for
technical support.
None.
None.
None.
None. This state is activated when the
OFFLINE/RESET switch is pressed for less
than 1 second to a start the process of an
orderly shutdown.
While in this state, do not remove any
DFE-Diamond module.
While in this state, you have 60 seconds to
safely remove the DFE-Diamond module
from the chassis.
None.
None.
None.
If it is known that the port should be
transmitting and is not, contact
Enterasys Networks for technical support.
None.
Using LANVIEW