This appendix covers the following items:
For information about...
Required Tools
Setting the Mode Switch
Memory Locations and Replacement Procedures
Required Tools
Use the following tools to perform the procedures provided in this appendix:
•
Antistatic wrist strap
•
Phillips screwdriver
Setting the Mode Switches
Figure
These switches are set at the factory and rarely need to be changed.
Switch definitions and positions are as follows:
•
Switches 1 through 6 – For Enterasys Networks use only.
Caution: An antistatic wrist strap is required to perform the procedures in this appendix. Use the
antistatic wrist strap when performing any of the procedures in this appendix to minimize ESD
damage to the devices involved.
Precaución: Para minimizar los efectos de las descargas de electricidad estática, deberá utilizar
una pulsera antiestática al realizar los siguiente procedimientos.
Caution: Read the appropriate sections to be fully aware of the consequences when changing
switch settings.
Only qualified personnel should change switch settings.
Precaución: Si desea modificar la configuración del interruptor, lea las secciones
correspondientes para saber cuál será el resultado de hacerlo.
Estas modificaciones a la configuración sólo debe realizarlas personal calificado.
B‐1 shows the location of the mode switches and the switch settings for normal operation.
Mode Switch Bank Settings
and Optional Installations
Matrix DFE-Platinum Series Module Installation Guide B-1
B
Refer to page...
B-1
B-1
B-2