Chapter 3: Installation; Important Notice - Enterasys Diamond Distributed Forwarding Engine 7KR4297-02 Hardware Installation Manual

Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes
Personal vorgenommen werden.
Read the Release Notes associated with the DFE-Diamond module to check for any exceptions to the
supported features and operation documented in this guide.
This chapter provides the instructions to install the DFE‐Diamond module and optional XFP
interface modules.
Note: Unless otherwise noted, the installation instructions for the DFE-Diamond modules apply to
both the 7KR4297-02 and 7KR4297-04 DFE-Diamond modules.
A Phillips screwdriver is required to install an optional interface module into the DFE‐Diamond
module. Follow the order of the sections listed below to correctly install the DFE‐Diamond
module.
For information about...
Unpacking the DFE-Diamond Module
Installing an Optional XFP Module
Backplane Connections and Installation Rules
Installing Module into Matrix E7 or Matrix N7 Chassis
Installing Module into Matrix N3 Chassis
Connecting to the Network
Connecting to COM Port for Local Management
Completing the Installation

Important Notice

Matrix DFE-Platinum Series Module Installation Guide 3-1
3
Installation
Refer to page...
3-2
3-2
3-3
3-6
3-9
3-10
3-11
3-16