Table of Contents
Advertisement
How to Use This Guide
How to Use This Guide
This preface provides an overview of this guide and the DFE‐Diamond Series manual set, a brief
summary of each chapter, and defines the conventions used in this document. To locate
information about various subjects in this guide, refer to the following table:
For...
An overview of the DFE module and instructions to
obtain technical support from Enterasys Networks
Network requirements that must be met before
installing the DFE module
Instructions to install the DFE module hardware
and optional XFP interface module
Troubleshooting installation problems and
diagnosing network/operational problems using the
LANVIEW LEDs
Specifications, environmental requirements, and
physical properties of the DFE module and optional
XFP interface module
Instructions to set the mode switches when
necessary and remove and replace DRAM SIMM
and DIMM memory
Related Documents
The manuals listed below can be obtained from the World Wide Web in Adobe Acrobat Portable
Document Format (PDF) at the following site:
http://www.enterasys.com/support/manuals
•
Enterasys Matrix™ DFE‐Diamond/Platinum Series Configuration Guide provides information on
how to use the Command Line Interface to set up and manage the DFE modules.
•
Cabling Guide provides information on dB loss and cable specifications.
Unlike the Enterasys Matrix™ DFE‐Diamond/Platinum Series Configuration Guide, the Cabling
Guide is not listed alphabetically on the web site. Instead, it is listed under the Overview Guides
link.
xii About This Guide
Refer to...
Chapter 1,
Introduction
Chapter 2,
Network Requirements
Chapter 3,
Installation
Chapter 4,
Troubleshooting
Appendix A,
Specifications
Appendix B,
Mode Switch Bank Settings and
Optional Installations
Advertisement
Table of Contents
Troubleshooting
