Using The Quick Install; Controlling The Projector Through A Wired Lan Environment - BenQ SH753P User Manual

Using the quick install

The projector provides a hot key to set Projector Installation, Test Pattern, and
Keystone quickly.
Press Quick Install on the remote control and press ▲/▼ to select:
• Projector Installation: See
• Test Pattern: See
• Keystone: See
Controlling the projector through a Wired LAN
environment
Wired LAN allows you to manage the projector from a computer using a web browser
when the computer and the projector are properly connected to the same local area
network.
Configuring the Wired LAN
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector
and the other end to the RJ45 port.
When connecting the RJ45 cable, avoid coiling and intertwining the cable as it may cause signal
noise or interruption.
2. Press MENU/EXIT and then press ◄/► until the System Setup: Advanced
menu is highlighted.
3. Press ▼ to highlight Network Settings and press MODE/ENTER. The
Network Settings page is displayed.
4. Press ▼ to highlight Wired LAN and press MODE/ENTER. The Wired LAN
page is displayed.
Press ▼ to highlight DHCP and press ◄/► to select On.
5.
6. Please wait for around 15 - 20 seconds, and then re-enter the Wired LAN page.
7. The IP Address, Subnet Mask, Default Gateway, and DNS Server settings will
be displayed. Note down the IP address displayed in the IP Address row.
Operation
"Positioning your projector" on page
"Using the test pattern" on page
"Correcting 2D Keystone" on page
18.
43.
27.
41