Maxtor ATLAS 10K III Product Manual page 37

Use Figure 3-5 to locate the appropriate pins for configuring the drive. Note that
Figure 3-5 does not call out each of the 80 pins on the connector, but rather
illustrates the layout of the pins.
Note: The SCA-2 Connector version of the disk drives does not provide
the following jumper configuration: TERMPWR, Active Termina-
tion, or Write Protection.
These versions of Maxtor Atlas 10K III disk drives cannot be
% # 7 6 + 1 0
configured to provide bus termination. Therefore, be sure to
properly terminate the SCSI bus on which this drive is in-
stalled.
Note: Refer to your system or SCSI controller documentation regard-
ing any additional recommendations regarding drive placement
on the SCSI bus and SCSI bus termination.
Each SCSI device on the bus must have a unique SCSI ID number assigned to it.
The drive can be configured for SCSI ID numbers that range from 0 through 15.
Configure the SCSI ID by providing the proper open or ground signal inputs to the
referenced pins of the drive's 80-pin new version SCA-2 connector (Figure 3-5).
Refer to Table 3-2 for SCSI ID pin assignments.
Note: Refer to your system or SCSI controller documentation for spe-
cific recommendations about assigning SCSI ID numbers for
your specific system.
4.60±0.50
Pin 80
Pin Locations on SCA-2 Connector
Installation
Pin 2
Pin 1
Maxtor Atlas 10K III 3-11