Seek (6) Command Descriptor Block-Data Format - Maxtor ATLAS 10K III Product Manual

The SEEK (6) command uses a 6-byte Command Descriptor Block to request the
drive to send the drive heads to the requested Logical Block Address. The drive
responds by placing the heads at the correct Logical Block Address. When the heads
are at the specified Logical Block Address, they are not guaranteed to stay in that
position since periodic calibrations may send them to a different cylinder. The data
format is shown in Table 5-195.
T a b l e 5 - 1 9 5 SEEK (6) Command Descriptor Block-Data Format
$ K V
 
$ [ V G
0
1 Reserved
2 - 3
4
5
  
Operation Code (0Bh)
Logical Block Address
Logical Block Address
Reserved
Control
SCSI Description
 
Maxtor Atlas 10K III

5-159