Negotiated Settings Subpage - Maxtor ATLAS 10K III Product Manual

SCSI Description
      0 G I Q V K C V G F 5 G V V K P I U 5 W D R C I G
The negotiated settings subpage, shown in Table 5-100, is used to report the
negotiated settings of a target for the current I_T nexus.
$ K V

$ [ V G
0
1
2
3
4 Reserved
5
6
7
The Transfer Period Factor field indicates the negotiated transfer period factor (see
Section 5.11.2.8, "Negotiated Rate Information Page (C4h)" on page 31) for the
current I_T nexus.
The Req/Ack Offset field indicates the negotiated REQ/ACK offset (see
Section 5.11.2.8, "Negotiated Rate Information Page (C4h)" on page 31) for the
current I_T nexus.
The Transfer Width Exponent field indicates the negotiated transfer width exponent
(see Section 5.11.2.8, "Negotiated Rate Information Page (C4h)" on page 31) for the
current I_T nexus.
The Protocol Options Bits field contain the negotiated protocol options (see
Section 5.11.2.8, "Negotiated Rate Information Page (C4h)" on page 31) for the
current I_T nexus.
The TRANSCEIVER MODE field specifies the current bus mode of the target as
defined in Table 5-101.
The SENT PCOMP_EN bit contains the value of the PCOMP_EN bit (see
Section 5.11.2.8, "Negotiated Rate Information Page (C4h)" on page 31) sent by the
target for the current I_T nexus.
The RECEIVED PCOMP_EN bit contains the value of the PCOMP_EN bit (see
Section 5.11.2.8, "Negotiated Rate Information Page (C4h)" on page 31) received by
the target for the current I_T nexus.
% Q F G
00b
01b
10b
11b
5-84 Maxtor Atlas 10K III
T a b l e 5 - 1 0 0 Negotiated Settings Subpage (03h)
  
Transfer Period Factor
Transfer Width Exponent
Reserved
T a b l e 5 - 1 0 1 Bus Mode
Unknown (device not capable of reporting bus mode)
Low-Voltage Differential
High-Voltage Differential
 
Reserved
Req/Ack Offset
Protocol Option Bits
Transceiver SENT_
Mode PCOMP_EN
Reserved
Vendor Specific
$ W U / Q F G
Single-ended
 
RECEIVED
PCOMP_EN