Maxtor ATLAS 10K III Product Manual page 209

0x06 0x86
0x06 0x87
0x06 0x88
0x06 0x89
0x06 0x8A
0x06 0x8B
0x06 0x8C
0x06 0x8D
0x06 0x8E
0x06 0x8F
0x06 0x90
0x06 0x91
0x04
0x06 0x92
Hdwe
Error
0x06 0x93
0x06 0x94
0x06 0x95
0x06 0x96
0x06 0x97
0x06 0x98
0x06 0x99
0x06 0x9A
0x06 0x9B
0x06 0x9C
0x06 0x9D
RECAL EC_RCL_SK_BIAS
RECAL EC_RCL_SK_KTJ
RECAL EC_RCL_SK_PES
RECAL EC_RCL_SVO_NOT_RDY
EC_RCL_SW_POINT_
RECAL
PARAM_BAD
EC_RCL_TRACK_NUM_
RECAL
BAD
EC_RCL_SK_SWITCH_
RECAL
POINT
RECAL EC_RECAL_MAP_HEADS
EC_RCL_NO_SAMS_
RECAL
FOUND
EC_RCL_SYNC_2_SPOKE_FAI
RECAL
L
RECAL EC_RCL_INVALID_CP18
RECAL EC_RCL_INVALID_CP21
RECAL EC_RCL_INVALID_CP22
EC_RCL_HEAD_POLARITY_FA
RECAL
IL
EC_RCL_CP22_HEAD_
RECAL
POLARITY
EC_RCL_ERASE_BAND_
RECAL
SK1
RECAL EC_RCL_SK_ARC
RECAL EC_RCL_SK_PESLIN
RECAL EC_RCL_PESLIN_BODE
EC_RCL_ERASE_BAND_
RECAL
SK2
EC_RCL_PESLIN_TABL_
RECAL
UPDATE
EC_RCL_TURBO_SPIN_
RECAL
RECOVERY
EC_RCL_BAD_ELEC_OFFSET
RECAL
_VAL
EC_RCL_HEAD_POLARITY_DE
RECAL
AD
SCSI Description
Seek failure during Bias
Calibration.
Seek failure during KT/J
Calibration.
Seek failure during PES
Calibration.
Recal servo not ready.
Switch Point calibration results
are bad.
Recal track number bad.
Seek failure during switch point
cal.
Not all Head(s) in USER head
map were found alive
Valid SAMs not found !!!
Sync To Disk Spokes failed.
Invalid CP18 on disk.
Invalid CP21 on disk.
Invalid CP22 in NVR.
Head polarity cal failed.
Invalid head polarity vector in
CP22.
Seek 1 failure during servo writer
erase band resync.
Seek failure during ARCs
Calibration.
Seek failure during Pes
Linearization.
Error during Pes Lin bode mea-
surement.
Seek 2 failure during servo writer
erase band resync.
Seek failure during pes
linearization table update.
Motor speed error after turbo
spin recovery.
Electrical offset calibration
returned an invalid value.
Went servo dead during head
polarity/coarse ATT cal.
Maxtor Atlas 10K III 5-145