Initiator-Changeable Mode Pages; Disconnect-Reconnect - Maxtor ATLAS 10K III Product Manual

SCSI Description
Table 5-53 lists the mode pages that are supported by the drive. An initiator can
change these pages by supplying them, with the desired changes included, in the
MODE SELECT command's data-out buffer transfer.
The initiator should first use a MODE SENSE command to read the appropriate pages
and leave non-changeable values as read when the initiator subsequently writes the
changeable pages with the MODE SELECT command. If a non-changeable field
contains an invalid value, the drive returns a CHECK CONDITION status.
00h Unit Attention Control Page
Read-Write Error Recovery Page
01h
02h Disconnect-Reconnect Page
1
07h
1
08h
1
0Ah
0Ch
10h
19h
1Ah
Information Exceptions Control
Page and operations of specific
1
1Ch
informational exception condi-
39h
NOTES:
1. This page is not supported by the SCSI-1/CCS Operating Mode.
2. The Notch and Partition page is changeable but NOT savable.
3. XOR is currently disabled and page is not changeable.
5-42 Maxtor Atlas 10K III
T a b l e 5 - 5 3 Initiator-Changeable Mode Pages
Verify Error Recovery Page
Caching Page
Control Mode Page
Notch and Partition Page
XOR Control Page
Port Control Page
Power Condition Page
tions.
Maxtor-Unique Page
Unit Attention report-
ing (enables or dis-
ables)
Medium Access Error
recovery and report-
ing procedures for
READ and WRITE
commands
Bus behavior during
data transfers
Medium Access Error
recovery and report-
ing procedures for the
VERIFY command
Cache policy
Command processing
policy
Drive geometry re-
2
porting
Controls XOR operat-
ing parameters
Defines port control
parameters
Enable and set time
intervals for Idle and
Standby modes
Defines methods to
control reporting
4
12
16
12
20
12
24
24
8
12
12
22