Oil Change; Topping-Up Oil - DURKOPP ADLER 806 Service Instructions Manual

2.10.5 Oil change

2.10.6 Topping-up oil

30
1 2
Caution: Danger of bodily injuries !
Turn off main switch.
Switch off the machine before proceeding to the oil change
The oil should be changed after the first 500 service hours as follows:
–
Remove the oil sump cover.
–
Such the oil. If sucking is impossible,
loosen the drain screw 3 and let the oil flow out.
–
Clean the oil sump and the breather tube.
–
Turn-in the drain screw 3 after having replaced its gasket.
–
Pour "ESSO SP-NK 10" oil through the filler neck 6 (s. page 26)
until the oil level stands in the upper third of the oil sight glass.
Caution: Danger of bodily injuries !
Turn off main switch.
Turn off the machine before replenishing.
Top up if, during the operation of the machine, the oil level stands in
the lower third of the sight glass 2 or when no oil supply can be seen
through the sight glass 5 (s. page 26).
Fill "ESSO SP-NK 10" oil through the filler neck 6 (s. page 26) until the
oil level stands in the upper third of the sight glass.
Other oil brands with the following specifications may be used:
Viscosity at 40°C:
Point of inflammation:
3
10 mm2/s
150 °C