Continuous Operation; End Bearing Switch Of The Transfer Carriage Available; Measuring The End Positions Of The Transfer Carriage - DURKOPP ADLER 806 Service Instructions Manual

6.3

Continuous operation

6.4 End position switch of the transfer carriage available
6.5

Measuring the end positions of the transfer carriage

By means of the "Continuous operation" function the 806 can be
switched over to the continuous operation mode for testing the
machine.
ATTENTION !
This function is intended exclusively for the internal use by
DÜRKOPP ADLER AG for testing the machine prior to the delivery.
In no case should this function be used outside.
Caution: Danger of bodily injuries !
The "continuous operation" function shall in no case be used outside.
The machine runs in the continuous operation mode without any
intervention by the user.
This function is not a sewing programme.
The lower left stop of the transfer carriage is determined mechanically.
The latest machines have limit switching for avoiding the collision of
the transfer carriage with the aforementioned stop.
If the machine is not fitted with limit switches, the control system will
ensure that the transfer carriage does not knock against the stop.
ATTENTION !
Do not switch on this function if the machine has no limit switch.
–
Check whether the machine is fitted with limit switches for the
lower left stop (see also chapter 7.4).
–
Use the function "End switch" for showing whether the machine is
fitted with limit switches.
If the machine is fitted with limit switches for the transfer carriage, it is
possible to measure the end position of the transfer carriage.
If the machine has no limit switches, standard values will be used for
the end position of the transfer carriage.
Measuring the end position
–
Select the function "Measuring the end position ".
The transfer carriage will perform a reference run.
The transfer carriage will move into the end positions of the
transfer carriage.
The values acquired will be memorised.
91