Y-Axis - DURKOPP ADLER 806 Service Instructions Manual

7.4.2

Y-Axis

1
2
3
4
96
Rule and control
The limit switch (S59) for the Y-axis limits the maximum sewing area in
respect to the pocket top edge. About 2 mm from the mechanical stop
the drives will be stopped in case of an automatic mode of operation.
–
When switching on the machine, hold the key "F3" pressed down.
The multicast menu will appear.
–
Select the function "Checking input elements ".
–
Select the switch S59.
–
.Lower the transfer carriage from the sewing position by
hand. When the circuit state of the limit switch changes, the display
will change
from "S59:+" to "S59:-".
–
Push the transfer carriage to the point where the switch acts.
–
The distance between the middle of the needle and the transfer
plate positioning hole 4 must amount to about 5 mm.
Correction
–
Loosen clamping screws 1 and 2.
–
Set limit switch 3.