General Information; Position Of The Entered Corner Introduction Slide - DURKOPP ADLER 806 Service Instructions Manual

4.5.2

General information

4.5.3 Position of the entered corner introduction knife
80
1
2
3
4
5
6
–
The purpose of the corner slide 6 is to place the fabric under the
30°-edge of the lateral slide 5, in order to avoid any fabric
projection in the pocket opening area.
–
In case of corner introduction slides for the class 806-111 attention
must be paid to the prescribed swivel position.
Double seam:
Single seam:
Caution: Danger of bodily injuries !
Do not introduce your hands into the area of the moving machine parts.
Rule and control
The amount of overlapping between the entered corner introduction
slide 6 and the lateral slide sheet 5 should range between 1 and 2 mm
, depending on the fabric type.
–
Select the "Single step mode" function.
–
Operate the "Start" key accordingly.
Correction
–
Loosen the screw 3 and the screw 4.
–
Change the position of the corner introduction slide 6 along the
arrow direction accordingly.
–
Tighten the screw 3 and the screw 4.
pin in the bore-hole 2 for a longer stroke
pin in the bore-hole 1 for a shorter stroke