Inner Frame; General Information; Adjustment Range Of The Front Setting Wheel - DURKOPP ADLER 806 Service Instructions Manual

4.2

Inner frame

4.2.1

General information

4.2.2

Adjustment range of the front setting wheel

1
2
3
4
5
6
–
The inner frame 4 is linked to its supports in a springy way at 3
points.
–
The vacuum field under the inner frame 4 sucks the middle slide,
so that it can be pulled up into the "Folding position".
The setting wheel 5 permits to determine "the folding position" of the
inner frame 4 and consequently also of the middle slide. The sticker on
the transfer plate shows the position of the setting wheel, required for
folding the fabric of the respective type. When adjusting the setting
wheel 5 note, that the main change of the "folding position" is in the
"lower" pocket section. A greater change in the "upper" pocket section
requires the adjustment by the setting wheel 1.
Caution: Danger of bodily injuries !
Do not introduce your hands into the area of the moving machine parts.
Rule and control
It should be possible to move the front slides 6 under the middle slide
at the smallest distance possible when the two settings wheels 1 and 5
are in "0" position and the inner frame 4 stands in the "folding position".
–
Move the setting wheel 1 and the setting wheel 5 in "0" position.
–
Select the "Single step mode" function.
–
Repeat pressing the "Start" key until the front slides 4 can be
advanced by hand.
Correction
–
Loosen the counter nut 3.
–
Turn the piston rod of the resetting element 2 accordingly.
–
Tighten the counter nut 3.
71