Sub-class -241291:
This sub-class is equipped with gimp pulling device.
Before the start of sewing it pulls the gimp back to the correct starting length.
For correct positioning see the Service Instructions.
–
Remove the clamp plates (see Chapter 2.1).
–
Turn the hand crank drehen until the hook bracket reaches the position shown.
The gimp pulling device 1 faces forward (to the seamstress).
–
Lead the gimp 2 from the lower gimp roll holder 4 through the side recess a in the
machine housing.
3 = Hook thread
–
Thread the gimp through the holes of the gimp pulling device 1.
For threading through the hole b press the brake flap 5 lying behind a little to the
back.
–
Thread the gimp 2 through the holes of the gimp guide c and gimp hole d of the
needle plate.
With the gimp pulling device in low position let an approx. 4 mm long gimp end look
out of the gimp hole of the needle plate.
–
Replace the clamp plates again (see Chapter 2.1).
4
1
a
2
d
c
b
3
5
1
33