Operation; Removal And Placement Of The Clamp Plates - Duerkopp Adler 558 Operating Instructions Manual

2. Operation

2.1 Removal and Placement of the Clamp Plates

The removal or placement of the clamp plates 3 and 5 occurs in the machine end
position (see Chapter 2.3).
The clamp operating lever 1 must be open !
This is the case when it is pushed to the back until it hits.
Sub-class -231391 and -251301:
Removing the clamp plates
–
Swing the clamp plate holder 2 away to the side.
–
Reach under each nail slit 6 and lift the clamp plate.
–
Remove the clamp plates to the front.
Placing the clamp plates
–
The clamp operators 8 must reach into the forks of the clamp arms.
–
Push the clamp plates to the right or left against the pressure screws 7 and plate
edges 9.
–
Place the clamp plates over the setbolt 10 on the material support plate.
–
Swing the clamp plates holder 2 back over the clamp plates.
The clamp plates are secured against lifting.
–
Check by closing the clamp operating lever 1 if the clamps open and close correctly.
Caution Risk of Injury !
Pull the mains plug.
Remove or place the clamp plates only with the machine
turned off.
ATTENTION !
In order to avoid damage to the needle the combined
finger-eye protection 4 must remain swung down.
15