Attachment; Pre-Assembling The Wiring Distributor - Duerkopp Adler 558 Operating Instructions Manual

5.6 Attachment

5.6.1 Pre-assembling the Wiring Distributor

The designation numbers affixed to the cables and position numbers in these
instructions are indentical with the cable numbers in the enclosed hook-up diagram
558 10296 and in the circuit diagram 558 10295.
–
Lay the cables 2 and 3 through the holder tube 12.
–
Connect the cores of the cables to the two outside terminals (1 and 4) of the
switches b1 and b2.
–
Fasten the switches b1 and b2 to angle 13.
–
Lay the cables 1 and 4 through the holder tube 11.
–
Connect the cores of cable 1 to magnet plug 10.
The terminal with the ground symbol remains free.
–
Connect the cores of the cable 4 at switch b3 to the terminals "Normally open" (3)
and "Common" (1).
–
Pull the cable brackets of cable 7 off of the connects in the wiring distributor L1.
Since the button b5 is already soldered on the freed cable end must be fed through
the holder tube 11 from above.
Push the cable brackets back onto the contacts (1 and 5).
–
Connect the cores of cable 6 to the two outside terminals (1 and 4) of the switch b4.
Caution Risk of Injury !
Pull the mains plug.
The attachment of the upper thread catcher may only be
conducted with the machine turned off and only by trained
skilled personnel.
97