2.14 Cutting Pressure
The cutting pressure is set with screw 1:
Increase cutting pressure
Decrease cutting pressure =
After each adjustment of screw 1 the cutting pressure must be checked.
Checking the cutting pressure
–
Turn the machine with the hand crank.
The cutting pressure may only be set so high that the hand crank can be turned at
the moment of cutting without exerting too much energy !
–
If even with this setting of the cutting pressure the cloth can still not be cleanly cut:
True the cutting block or check the sharpness of the knife blade (see Chapter 2.13).
58
=
turn to the right
turn to the left
ATTENTION !
Excessive cutting pressure leads to unnecessary wear of
the cutting tools !
1