5.6.6 Mounting the Upper Thread Catcher on the Machine Arm
b5
4
5
6
7
8
–
Remove the head cover 8.
–
Replace the protecting bar 10 for the upper toothed segment with the at the right
side shortened protecting bar found in the parts set.
–
Reattach head cover 8 again.
–
Fasten the mounting angle 2 for the thread catcher with screws 1 and 3 to the
machine arm.
–
Fasten stopper angle 11 to the toothed segment.
–
Attach the thread catcher base plate 6 with screws 5, 7 and 12 to the mounting
angle 2.
Thereby place holder 4 for switch b5 under the screws 5 and 7.
–
Mount switch b5 on holder 4.
–
Place plug 9 onto magnet s1 and secure with a screw.
–
Fasten the cables with clamps and cable bindings.
104
1
2
s1
9
3
10
11
12