Duerkopp Adler 558 Operating Instructions Manual page 15

Sub-classes -211241, -221301 and -241291:
Removing the clamp plates
–
Swing the clamp plate holder 1 away to the side.
–
Pull the spring mounted slide 3 in the direction of the arrow and remove the right
clamp plate.
–
Reach under the nail slit 2 and remove the left clamp plate.
Placing the clamp plates
–
Place first the left, then the right clamp plate.
–
The clamp operators 5 must reach into the forks of the clamp arms.
–
Push the clamp plates to the right or left against the pressure screws 4 and plate
edges 6.
–
Place the clamp plates over the setbolt 7 on the the material support plate.
Hereby pull the spring mounted slide 3 in the direction of the arrow and let catch in
groove 8.
–
Swing the clamp plate holder 1 over the clamp plates again.
The clamp plates are secured against lifting.
–
Check by closing the clamp operating lever if the clamps open and close correctly.
4
1
5
6
7
4
1
5
6
7
8
17