2.16 Stitch Density
For the whole buttonhole length
The stitch density is adjustable between 0.9 and 2 mm.
It is determined by the required strength and the appearance of the buttonhole, as well
as the thread size used.
–
Loosen screw 2.
–
Move the transport lever 1.
Movement in direction A
Movement in direction B
–
Tighten screw 2 again.
In the eye of the buttonhole
This setting has no influence on the stitch density in both seam rows.
Stitch density in the buttonhole eye to be smaller:
–
Loosen screw 4.
–
Move the stitch length regulator rail 5 in the direction of the arrow.
–
Tighten screw 4 again.
Stitch density in the buttonhole eye to be greater:
–
Loosen screw 4.
–
Replace the old stitch length regulator rail 5 with the stitch length regulator rail 3
found in the accessories pack.
–
Tighten screw 4 again.
3
Caution Risk of Injury !
Pull the mains plug.
Set the stitch density only with the machine turned off.
=
stitches become denser
=
stitche are farther apart
5
61