Control Unit - Duerkopp Adler 558 Operating Instructions Manual

5.6.3 Control Unit

–
Mount the control unit 2 under the table.
–
Lay the cable 1 from the wiring distributor to the control unit 2 (plug b10) and aatch
to the table with a clamp.
The laying of the cable must be conducted with the machine head tilted up.
–
Connect the mains lead and connector lead to the motor as per the hook-up
diagram.
ATTENTION
After connecting the sewing procfedure may only be turned
on if all setting have previously been made according to
Chapter 5.5.
1
2
101