Selecting The Power Setting - Raymarine hsb2 series Owner's Handbook Manual

Chapter 3: Getting Started & Adjusting the Display
Note:
1. Range detection below 3000 ft (1000 m) is only available with the L1250
Plus and L1250RC Plus displays after you have fixed the Depth Range set-
ting to 5000 ft. See Depth Range (L1250 Plus and L1250RC Plus only) on
page 7-13 for details.
2. All other
3000 ft (1000 m), unless repeating data from an L1250 Plus or L1250RC
Plus via the High Speed Bus.
To adjust the range and shift values:
1. Press RANGE, this sets adjustment to manual and the range soft keys are
displayed. The range adjusts up or down depending on the direction
RANGE
pressed.
2. Use the RANGE key to adjust the range: press the up arrow to select a shal-
lower range, press the down arrow to select a deeper range.
3. If necessary, press the RANGE AUTO MAN soft key to select AUTO range.
AUTO range is indicated by the letter R in the status bar.
4. To adjust the shift, press the appropriate SHIFT soft key: use the up soft key
to select a shallower shift, use the down soft key to select a deeper shift.
The image window is shifted up by the selected amount
5. Press ENTER to return to the default display.

Selecting the Power Setting

The POWER soft key provides adjustment of the transducer signal. When AUTO
is selected (default), the Fishfinder automatically determines the power
setting based on the current depth. LO power (10 W) is used in depth ranges
less than 20 feet and HI power (600 or 1000 W, depending on your transducer)
is selected for depths greater than 20 feet. When AUTO is selected the current
automatic power setting is indicated in the top status line by an L (low) or H
(high).
If, however, you wish to manually adjust the power to suit current conditions,
you can select either LO or HI power.
The power setting is retained when the unit is powered off.
To change the power setting:
MULTI
1. Press the MULTI key to display the soft key controls.
2. Press the POWER soft key to toggle between AUTO, LO, or HI power. The
selected setting is highlighted.
3. Press ENTER or CLEAR to return to the default screen.
hsb Series Fishfinders are limited to a maximum depth range of
2
3-17