Moving A Waypoint - Raymarine hsb2 series Owner's Handbook Manual

Chapter 5: Standard Chart Operations
To delete a waypoint using the cursor:
1. Move the cursor over the waypoint, until the letters WPT are displayed. The
WPT
waypoint soft keys are displayed.
2. Press the ERASE WAYPOINT soft key. The waypoint is removed from the
ERASE
WAYPOINT
screen and the Waypoint List is updated.
Note: If you have stopped a GOTO (see Stop Follow or Stop Goto on
page 5-32), the target waypoint remains displayed as a target; you need to use
the CLEAR GOTO soft key before you can erase the waypoint using the cursor.
To delete a waypoint using the waypoint list:
1. Select the waypoint from the waypoint list as previously described. The
MARKS
waypoint list soft keys are displayed.
2. Press the EDIT WAYPOINT soft key, followed by ERASE WAYPOINT. The way-
WAYPOINT
LIST
point is removed from the screen and the waypoint list is updated.

Moving a Waypoint

You can move any waypoint except the target waypoint (the waypoint you are
following). You can use the Waypoint soft keys and cursor to move the
selected waypoint, or you can edit the waypoint position.
CAUTION:
Take care when editing waypoints as it is possible to move waypoints that
are used in routes stored in the Route Database
To move a waypoint using the cursor:
1. Move the cursor over the waypoint, until the letters WPT are displayed. The
WPT
waypoint soft keys are displayed.
MOVE
2. Press MOVE WAYPOINT, the cursor changes to a four-headed arrow.
WAYPOINT
3. Move the cursor to the required waypoint position.
Press ENTER to set the position and return to normal cursor control.
Press CLEAR to cancel the operation.
To move a waypoint using the Waypoint Edit functions:
1. Select the waypoint using either the cursor or the waypoint list as described
above. The waypoint soft keys are displayed.
2. To edit the waypoint position proceed as previously described in Editing
the Waypoint Details on page 5-13.
5-15
List.