Data Conversion - Raymarine hsb2 series Owner's Handbook Manual

2-28
NMEA OUT connector
Pin 2, white
Pin 5, screen
Rear of display
Figure 2-18: NMEA Output Connector

Data Conversion

The
hsb
communications links as follows:
NMEA In to NMEA Out and SeaTalk
SeaTalk to NMEA Out
This enables data received by the display to be passed to other instruments. For
example, if you have a master and a repeater display, you only need to connect
NMEA In to the master display, which will pass the data to the repeater via
SeaTalk.
You can prevent NMEA heading data being bridged onto the SeaTalk bus -
refer to Bridge NMEA Heading on page 7-9.
Note: To transfer NMEA data, or to convert the data, the display must be pow-
ered On.
Pin 3, blue
Pin 4, not connected
3
4
Series displays convert some information across the
2
NMEA OUT connector
Pin Pin name
2 NMEA_GND
3 NMEA_SIG
4 N/C
5 CGND
*Pin 1 does not exist on this connector
2
NMEA out
5
hsb Series Fishfinders
2
Function
NMEA ground
NMEA data output
N/C
Screen
D4254_1