Waypoint Data Display - Raymarine hsb2 series Owner's Handbook Manual

5-12
To select a waypoint using the cursor:
1. Move the cursor over the waypoint, until the letters WPT are displayed.
The Waypoint Data box (see Waypoint Data Display on page 5-12) and the
WPT
following soft keys are displayed:
The selected waypoint can be edited via these soft keys.
To select a waypoint using the Waypoint List:
1. Press MARKS, followed by the WAYPOINT LIST soft key.
The Waypoint List and associated soft keys are displayed.
MARKS
The list details all waypoints in alpha-numeric order. The selected way-
WAYPOINT
point is indicated by the selection bar; its position, bearing and range are
LIST
provided.
2. Use the trackpad to move the selection bar up and down the list to highlight
the required waypoint.
or
Use the ST80 Navigator to select to highlight the required waypoint, as
described in Using the ST80 Navigator Keypad on page 5-16.
The selected waypoint can be edited via the soft keys displayed.

Waypoint Data Display

Waypoint data can be viewed in two ways: you can use the context-sensitive
cursor to select the waypoint and thus display the waypoint data box, or you
can view waypoint details on the waypoint list.
Note: To permanently display the target waypoint data box, select it in the
System Set Up menu (see Section 7.3) and use the SCREEN soft key to switch
data boxes on.
To display the waypoint data box, move the cursor over the waypoint.
The waypoint data box is displayed, this indicates waypoint number/name,
bearing and range (or latitude and longitude if selected in the system set up
menu).
WAYPOINT 001
BRG
RNG
While the cursor is over the waypoint, the waypoint soft keys are displayed.
o
191 T
2.2nm
D4250-1
hsb Series Fishfinders
2
D4163-1