To save the running configuration to a configuration file, use the following command:
save config [filename]
If you do not specify a filename of up to 128 alphanumeric characters, the command replaces the
startup configuration file that was loaded the last time the software was rebooted.
To save the running configuration to the file loaded the last time the software was rebooted, type the
following command:
DWS-1008# save config
success: configuration saved.
To save the running configuration to a file named newconfig, type the following command:
DWS-1008# save config newconfig
success: configuration saved to newconfig.
Specifying the Configuration File to Use After the Next
By default, the switch loads the configuration file named configuration from nonvolatile storage following
a software reboot. To use a different configuration file in nonvolatile storage after rebooting, use the
following command:
set boot configuration-file filename
To configure a switch to load the configuration file floor2mx from nonvolatile storage following the next
software reboot, type the following command:
DWS-1008# set boot configuration-file floor2mx
success: boot config set.
D-Link DWS-1008 User Manual
Saving Configuration Changes
Reboot
08