D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual page 118

To clear a notification target, use the following command:
clear snmp notify target target-num
The target-num is an ID for the target. This ID is local to the switch and does not need to correspond to
a value on the target itself. You can specify a number from 1 to 10.
The ip-addr[:udp-port-number] is the IP address of the server. You also can specify the UDP port number
to send notifications to. The default is 162.
Use v1, v2c, or usm to specify the SNMP version.
The inform or trap option specifies whether the MSS SNMP engine expects the target to acknowledge
notifications sent to the target by the switch. Use inform if you want acknowledgements. Use trap if you
do not want acknowledgements. The inform option is applicable to SNMP version v2c or usm only.
The username is a USM username, and is applicable only when the SNMP version is usm. If the user
will send informs rather than traps, you also must specify the snmp-engine-id of the target. Specify ip if
the target's SNMP engine ID is based on its IP address. If the target's SNMP engine ID is a hexadecimal
value, use hex hex-string to specify the value.
The community-string is applicable only when the SNMP version is v1 or v2c.
The profile-name is the notification profile. The default is default.
The security option specifies the security level, and is applicable only when the SNMP version is usm:
unsecured - Message exchanges are not authenticated, nor are they encrypted. This is the
default.
authenticated - Message exchanges are authenticated, but are not encrypted.
encrypted - Message exchanges are authenticated and encrypted.
The retries and timeout options are applicable only when the SNMP version is v2c or usm and the
notification type is inform. The retries option specifies the number of times the MSS SNMP engine will
resend a notification that has not been acknowledged by the target. You can specify from 0 to 3 retries.
The default is 0. The timeout option specifies the number of seconds MSS waits for acknowledgement
of a notification. You can specify from 1 to 5 seconds. The default is 2.
D-Link DWS-1008 User Manual