5056-XXX
Periodic maintenance
This table lists the parts to be periodically cleaned by the servicer.
Part name
Paper feed unit
Registration unit
Charge/exposure
unit
Transfer unit
Fuser unit
Outer covers
Lubricants and cleaners
Lubricating
• Oil–#10: Apply between gears
and shafts.
• Grease–# 23: Apply to gears.
6-2
Service Manual
Method
• Pick roller
Remove any dust or dirt, and wipe the surface lightly with a dry
cloth. If it is still dirty, clean with a soft cloth and alcohol.
• Separator roller
• Paper feed roller
• MPF roll
Registration roller,
Remove any dust or dirt, and wipe the surface lightly with a dry
upper and lower
cloth. If it is still dirty, clean with a soft cloth and alcohol.
LED head
Remove any dust or dirt, and wipe the surface lightly with a dry
cloth. If it is still dirty, clean with a soft cloth and alcohol.
Transfer belt
Remove any dust or dirt, and wipe the surface lightly with a dry
cloth. If it is still dirty, clean with a soft cloth and alcohol.
Heat rollers
Clean with a soft cloth, silicon oil, or alcohol.
Use a synthetic detergent and a damp cloth.
Cleaning
Alcohol or isopropyl on plastic, rubber,
and external parts.