Lowering Or Raising The Finisher - Lexmark C920 Service Manual

5056-XXX

Lowering or raising the finisher

Follow these instructions if the holes on the finisher are above or below the pins on the docking plate.
1.
Determine if the pins are above or below the holes in the finisher.
2.
Loosen the guide rail thumbscrews.
3.
Rotate the adjustment knobs as needed to align the holes in the finisher with the pins.
•
To raise the finisher, rotate the adjustment knobs clockwise.
•
To lower the finisher, rotate the adjustment knobs counterclockwise.
3-60
Service Manual
Alignment Marks
Spacing
Pin
Hole in Finisher