Lexmark C920 Service Manual page 76

5056-XXX
Message
Menus are Disabled
Network
Network <x>
Network <x>, <y>
No DRAM installed
No held jobs
No jobs found
No jobs to cancel
No recognized file types
Parallel
Parallel <x>
Port disabled Remove USB drive
Power Saver
Printer locked, enter PIN to unlock The operator panel has been
Printing
Printing from USB drive
DO NOT REMOVE
Printer busy
Continue
Quit
Programming System Code
Programming Flash
Programming Disk
Reading USB drive DO NOT
REMOVE
2-34
Service Manual
Meaning
The printer menus are disabled.
You cannot change the printer
settings from the operator panel.
See action column.
See action column.
The DRAM is missing or not
properly installed.
The four-digit personal
identification number (PIN) you
entered is not associated with any
confidential print job.
See action column.
The printer is in Power Saver
Mode. It is ready to receive a print
job.
locked.
A job on the USB drive is being
processed.
New system code is being
programmed into the printer.
Printer resources are being stored
to the flash memory.
Printer resources are being stored
to the hard disk drive.
Action
Note: You can still cancel a job, print
a confidential job, or print a held job.
A network interface is the active
communication link.
A network interface is the active
communication link, where <x>
represents the active communication
link, and <y> represents the channel.
Turn the printer off, and install
DRAM.
Wait for the message to clear.
Select Try again to enter another
PIN.
Select Cancel to exit the Enter
PIN screen.
Wait for the message to clear.
Wait for the message to clear.
Note: The only supported file type is
PDF.
A parallel interface is the active
communication link.
Wait for the message to clear.
Send a job to print.
Press Select to warm the printer to
normal operating temperature and
display the Ready message.
Enter the correct PIN number to
unlock the printer.
Wait for the message to clear.
Warning: Do not turn the printer off
or remove the USB drive while this
message is displayed.
Wait for the message to clear.
Select Continue to read the
information from the USB drive.
Select Quit to cancel the
information retrieval process.
Warning: Do not turn the printer off
while this message is displayed.
Wait for the message to clear and
the printer to reset.
Warning: Do not turn the printer off
while this message is displayed.
Wait for the message to clear.
Warning: Do not turn the printer off
while this message is displayed.
Wait for the message to clear.
Wait for the message to clear.