Lexmark C920 Service Manual page 81

Message
40 Tray <x> size sense error
41 Open bin 1 exit tray
51 Defective flash detected
52 Not enough free space in flash
memory for resources
53 Unformatted flash detected
54 Serial option <x> error
54 Network <x> software error
54 Standard network software
error
55 Unsupported flash option in
slot <x>
55 Unsupported option in slot <x>
Meaning
The hi-cap feeder detects an error
in the size sensing mechanism.
The printer wants to send a job to
the bin 1 output tray, but the tray is
closed.
Self explanatory.
Self explanatory.
Self explanatory.
The printer has detected a serial
interface error on a serial port.
The printer cannot establish
communications with the specified
network port.
Action
-Select Continue to clear the
message and continue printing.
The job may not print correctly.
-Cancel the current job.
-Turn the printer off, check high
capacity feeder connectors, then turn
the printer on.
-Open the bin 1 exit tray located on
the left side of the printer.
-Cancel the current job.
-Select Continue to clear the
message and print to another output
bin.
Select Continue to clear the
message and continue printing.
You must install different flash
memory before you can download
any resources to flash.
-Select Continue to clear the
message and continue printing.
Downloaded fonts and macros not
previously stored in flash memory
are deleted.
-Delete fonts, macros, and other data
stored on the flash memory.
-Install a larger capacity flash
memory card.
Select Continue to clear the
message and continue printing.
You must format the flash memory
before you can store any resources
on it. If the error message remains,
the flash memory may be defective
and require replacing.
-Make sure the serial link is set up
correctly, and you are using the
appropriate cable.
-Make sure the serial interface
parameters (protocol, baud, parity,
and data bits) are set correctly on the
printer and host computer.
-Select Continue to clear the
message and continue printing.
The job may not print correctly.
-Turn the printer off and then on to
reset the printer.
-Select Continue to clear the
message and continue printing.
The job may not print correctly.
-Program new firmware for the
network interface.
-Reset the printer.
1. Turn the printer off.
2. Remove the unsupported option.
3. Turn the printer on.
Diagnostic information
5056-XXX
2-39