Displaying Ip Source Guard Information - Cisco 3750G - Catalyst Integrated Wireless LAN Controller Configuration Manual

Chapter 22 Configuring DHCP Features and IP Source Guard
Command
Step 8
show ip source binding [ip-address]
[mac-address] [dhcp-snooping | static]
[inteface interface-id] [vlan vlan-id]
Step 9
copy running-config startup-config
To disable IP source guard with source IP address filtering, use the no ip verify source interface
configuration command.
To delete a static IP source binding entry, use the no ip source global configuration command.
This example shows how to enable IP source guard with source IP and MAC filtering on VLANs 10
and 11:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# ip verify source port-security
Switch(config-if)# exit
Switch(config)# ip source binding 0100.0022.0010 vlan 10 10.0.0.2 interface
gigabitethernet1/0/1
Switch(config)# ip source binding 0100.0230.0002 vlan 11 10.0.0.4 interface
gigabitethernet1/0/1
Switch(config)# end

Displaying IP Source Guard Information

To display the IP source guard information, use one or more of the privileged EXEC commands in
Table
Table 22-3 Commands for Displaying IP Source Guard Information
Command
show ip source binding
show ip verify source
OL-8550-02
Purpose
Display the IP source bindings on the switch, on a specific VLAN, or on
a specific interface.
(Optional) Save your entries in the configuration file.
22-3:
Purpose
Display the IP source bindings on a switch.
Display the IP source guard configuration on the switch.
Displaying IP Source Guard Information
Catalyst 3750 Switch Software Configuration Guide
22-19