Assigning Stack Member Information; Assigning A Stack Member Number; Setting The Stack Member Priority Value - Cisco 3750G - Catalyst Integrated Wireless LAN Controller Configuration Manual

Configuring the Switch Stack
Switch#
----------------------------------------------------------
*1

Assigning Stack Member Information

These sections describe how to assign stack member information:
•
•
•

Assigning a Stack Member Number

This task is available only from the stack master.
Note
Beginning in privileged EXEC mode, follow these steps to assign a member number to a stack member.
This procedure is optional.
Command
Step 1 configure terminal
Step 2
switch current-stack-member-number
renumber new-stack-member-number
Step 3
end
Step 4 reload slot stack-member-number
Step 5 show switch
Step 6
copy running-config startup-config

Setting the Stack Member Priority Value

This task is available only from the stack master.
Note
Beginning in privileged EXEC mode, follow these steps to assign a priority value to a stack member:
This procedure is optional.
Command
Step 1
configure terminal
Catalyst 3750 Switch Software Configuration Guide
5-22
Role Mac Address
Master 0016.4727.a900
Assigning a Stack Member Number, page 5-22
Setting the Stack Member Priority Value, page 5-22
Provisioning a New Member for a Switch Stack, page 5-23
H/W Current
Priority Version
1 0
(optional)
Purpose
Enter global configuration mode.
Specify the current stack member number and the new stack member
number for the stack member. The range is 1 to 9.
You can display the current stack member number by using the show
switch user EXEC command.
Return to privileged EXEC mode.
Reset the stack member.
Verify the stack member number.
Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Chapter 5 Managing Switch Stacks
State
Ready
(optional)
(optional)
OL-8550-02