Configuring Egress Queue Characteristics - Cisco 3750G - Catalyst Integrated Wireless LAN Controller Configuration Manual

Chapter 33 Configuring QoS
Beginning in privileged EXEC mode, follow these steps to configure the priority queue. This procedure
is optional.
Command
Step 1
configure terminal
Step 2 mls qos srr-queue input
priority-queue queue-id bandwidth
weight
Step 3 end
Step 4 show mls qos interface queueing
or
show mls qos input-queue
Step 5
copy running-config startup-config
To return to the default setting, use the no mls qos srr-queue input priority-queue queue-id global
configuration command. To disable priority queueing, set the bandwidth weight to 0, for example, mls
qos srr-queue input priority-queue queue-id bandwidth 0.
This example shows how to assign the ingress bandwidths to the queues. Queue 1 is the priority queue
with 10 percent of the bandwidth allocated to it. The bandwidth ratios allocated to queues 1 and 2 is
4/(4+4). SRR services queue 1 (the priority queue) first for its configured 10 percent bandwidth. Then
SRR equally shares the remaining 90 percent of the bandwidth between queues 1 and 2 by allocating 45
percent to each queue:
Switch(config)# mls qos srr-queue input priority-queue 1 bandwidth 10
Switch(config)# mls qos srr-queue input bandwidth 4 4

Configuring Egress Queue Characteristics

Depending on the complexity of your network and your QoS solution, you might need to perform all of
the tasks in the next sections. You will need to make decisions about these characteristics:
•
•
•
•
•
OL-8550-02
Purpose
Enter global configuration mode.
Assign a queue as the priority queue and guarantee bandwidth on the stack
ring if the ring is congested.
By default, the priority queue is queue 2, and 10 percent of the bandwidth
is allocated to it.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Which packets are mapped by DSCP or CoS value to each queue and threshold ID?
What drop percentage thresholds apply to the queue-set (four egress queues per port), and how much
reserved and maximum memory is needed for the traffic type?
How much of the fixed buffer space is allocated to the queue-set?
Does the bandwidth of the port need to be rate limited?
How often should the egress queues be serviced and which technique (shaped, shared, or both)
should be used?
For queue-id, the range is 1 to 2.
•
For bandwidth weight, assign the bandwidth percentage of the stack
•
ring. The range is 0 to 40. The amount of bandwidth that can be
guaranteed is restricted because a large value affects the entire ring
and can degrade the stack performance.
Catalyst 3750 Switch Software Configuration Guide
Configuring Standard QoS
33-71