Connectivity To Specific Stack Members; Switch Stack Configuration Scenarios - Cisco 3750G - Catalyst Integrated Wireless LAN Controller Configuration Manual

Chapter 5 Managing Switch Stacks
Be careful when using multiple CLI sessions to the stack master. Commands that you enter in one session
are not displayed in the other sessions. Therefore, it is possible that you might not be able to identify the
session from which you entered a command.
We recommend using only one CLI session when managing the switch stack.

Connectivity to Specific Stack Members

If you want to configure a specific stack member port, you must include the stack member number in the
CLI command interface notation. For more information, see the
section on page
To debug a specific stack member, you can access it from the stack master by using the session
stack-member-number privileged EXEC command. The stack member number is appended to the system
prompt. For example,
system prompt for the stack master is
CLI session to a specific stack member.

Switch Stack Configuration Scenarios

Table 5-2
switches are connected through their StackWise ports.
Table 5-2

Switch Stack Configuration Scenarios

Scenario
Stack master election
specifically determined
by existing stack masters
Stack master election
specifically determined
by the stack member
priority value
Stack master election
specifically determined
by the configuration file
OL-8550-02
11-10.
Switch-2#
provides switch stack configuration scenarios. Most of the scenarios assume at least two
Connect two powered-on switch stacks
through the StackWise ports.
Connect two switches through their
1.
StackWise ports.
Use the switch stack-member-number
2.
priority new-priority-number global
configuration command to set one stack
member with a higher member priority
value.
3. Restart both stack members at the same
time.
Assuming that both stack members have the
same priority value:
Make sure that one stack member has a
1.
default configuration and that the other
stack member has a saved (nondefault)
configuration file.
2. Restart both stack members at the same
time.
is the prompt in privileged EXEC mode for stack member 2, and the
. Only the show and debug commands are available in a
Switch
Result
Only one of the two stack masters becomes the new
stack master. None of the other stack members
become the stack master.
The stack member with the higher priority value is
elected stack master.
The stack member with the saved configuration file
is elected stack master.
Catalyst 3750 Switch Software Configuration Guide
Understanding Switch Stacks
"Using Interface Configuration Mode"
5-17