Setting The Sdm Template - Cisco 3750G - Catalyst Integrated Wireless LAN Controller Configuration Manual

Configuring the Switch SDM Template

Setting the SDM Template

Beginning in privileged EXEC mode, follow these steps to use the SDM template to maximize feature
usage:
Command
Step 1
configure terminal
Step 2 sdm prefer {access | default |
dual-ipv4-and-ipv6 {default | routing |
vlan} | routing | vlan} [desktop]
Step 3 end
Step 4
reload
After the system reboots, you can use the show sdm prefer privileged EXEC command to verify the new
template configuration. If you enter the show sdm prefer command before you enter the reload
privileged EXEC command, the show sdm prefer command shows the template currently in use and the
template that will become active after a reload.
Catalyst 3750 Switch Software Configuration Guide
8-6
Purpose
Enter global configuration mode.
Specify the SDM template to be used on the switch:
The keywords have these meanings:
access—Maximizes system resources for ACLs.
•
default—Gives balance to all functions.Visible on Catalyst
•
3750-12S switches to use with the desktop keyword to set the
switch to the default desktop template. (Use the no sdm prefer
command to set a desktop switch to the default desktop template
or to set an aggregator switch to the default aggregator template.)
dual-ipv4-and-ipv6—Select a template that supports both IPv4
•
and IPv6 routing.
default—Balance IPv4 and IPv6 Layer 2 and Layer 3
–
functionality.
routing—Provide maximum usage for IPv4 and IPv6
–
routing, including IPv4 policy-based routing.
vlan—Provide maximum usage for IPv4 and IPv6 VLANs.
–
routing—Maximizes routing on the switch.
•
vlan—Maximizes VLAN configuration on the switch with no
•
routing supported in hardware.
desktop—Supported only on Catalyst 3750-12S switches. Sets
•
the switch to the default, routing, or VLAN desktop template.
The default templates balance the use of system resources.
Return to privileged EXEC mode.
Reload the operating system.
Chapter 8 Configuring SDM Templates
OL-8550-02