Cisco 3750G - Catalyst Integrated Wireless LAN Controller Configuration Manual page 739

Chapter 33 Configuring QoS
Command
Step 3
auto qos voip {cisco-phone |
cisco-softphone | trust}
Step 4 end
Step 5 show auto qos interface interface-id
To display the QoS commands that are automatically generated when auto-QoS is enabled or disabled,
enter the debug auto qos privileged EXEC command before enabling auto-QoS. For more information,
see the debug autoqos command in the command reference for this release.
To disable auto-QoS on a port, use the no auto qos voip interface configuration command. Only the
auto-QoS-generated interface configuration commands for this port are removed. If this is the last port
on which auto-QoS is enabled and you enter the no auto qos voip command, auto-QoS is considered
disabled even though the auto-QoS-generated global configuration commands remain (to avoid
disrupting traffic on other ports affected by the global configuration).
You can use the no mls qos global configuration command to disable the auto-QoS-generated global
configuration commands. With QoS disabled, there is no concept of trusted or untrusted ports because
the packets are not modified (the CoS, DSCP, and IP precedence values in the packet are not changed).
Traffic is switched in pass-through mode (packets are switched without any rewrites and classified as
best effort without any policing).
This example shows how to enable auto-QoS and to trust the QoS labels received in incoming packets
when the switch or router connected to a port is a trusted device:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# auto qos voip trust
OL-8550-02
Purpose
Enable auto-QoS.
The keywords have these meanings:
cisco-phone—If the port is connected to a Cisco IP Phone, the
•
QoS labels of incoming packets are trusted only when the
telephone is detected. This keyword is not supported on
10-Gigabit interfaces.
cisco-softphone—The port is connected to device running the
•
Cisco SoftPhone feature. This keyword is not supported on
10-Gigabit interfaces.
Note The cisco-softphone keyword is supported only in Cisco IOS
Release 12.2(20)SE or later.
trust—The uplink port is connected to a trusted switch or router,
•
and the VoIP traffic classification in the ingress packet is trusted.
Return to privileged EXEC mode.
Verify your entries.
This command displays the auto-QoS command on the interface on
which auto-QoS was enabled. You can use the show running-config
privileged EXEC command to display the auto-QoS configuration
and the user modifications.
Catalyst 3750 Switch Software Configuration Guide
Configuring Auto-QoS
33-27